top of page

TECHNICAL SPECIFICATIONS

Pump type:

Grinder

Electrical:

120 V – 60 Hz / 9 Amps (Max)

Motor:

1 HP oil-filled thermally protected motor

Capacitor rating:

60 microfarad

Operating Temperature:

104ÅãF (110ÅãF Max.)

Power cord length:

49 inches

Noise level:

≤ 63 dBA (Lp) (measured at 3 ft.)

Discharge pipe diameter:

3⁄4” or 1”

Discharge rate at 25 ft:

19 GPM

Discharge rate at 3 ft:

38 GPM

Shut-off head:

38 ft.

Normal running time:

10-12 seconds

Capacity:

3.2 gallons / 12.1 liters

Inlets:

2” (side), 1–1⁄2” vent (top)

Method of activation:

Membrane/microswitch

Shower/bathtub base height:

8” min

Weight:

28 lbs / 12.7 kg

Certifying agencies:

CSA (IPC, NSPC), IAPMO (UPC)

Recommended accessories:

Descaler, Sanialarm

Connections:

Rear outlet toilet, sink, shower/bathtub, washing

20 -5/16" machine (indirect connection via laundry sink)

Sanibest Pro - 
AVAILABLE IN STORE

Sani 013

DESCRIPTION

The Sanibest Pro is a 1 HP pump system used to install a complete bathroom up to 25 feet below the

sewer line, or even up to 150 feet away from a soil stack. It incorporates a grinder system which is ideal

for uncontrolled environments in both residential and commercial applications (ie. rental unit, offices,

warehouses, etc). The Sanibest Pro is designed to handle sanitary products that may have been flushed

down the toilet; such may consist of condoms, sanitary napkins, q-tips, dental floss, etc.

Discharges the waste through a 3 ⁄4” or 1” rigid pipe. A non-return valve is included on the discharge

PRODUCT INFO

  • Discharges the waste through a 3 ⁄4” or 1” rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the system. This elbow can be rotated 360 degrees depending on the discharge installation.

  • Has been designed with a 1–1⁄ 2” vent connection on the top of the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.

  • Must be connected to Saniflo’s 1.28 GPF / 4.8 LPF rear discharge toilet. These toilets come in round and elongated (ADA compliant) models. More technical information on page 6.

  • Will also discharge gray water from any sink, bath/shower, urinal and even a washing machine (indirect connection). The wastewater will drain into the system via two 2” inlets with built-in check valves on either side of the housing. Note that when adding a bathtub/shower, the base should be raised up by a minimum of 8” off the floor.

  • An easy access service panel is located on top of the pump. This will give you easy access to the electrical components such as the capacitor,

bottom of page