top of page
This site was designed with the
.com
website builder. Create your website today.Start Now

TECHNICAL SPECIFICATIONS

Pump type:

Grinder

Electrical:

120 V – 60 Hz / 9 Amps (Max)

Motor:

1 HP oil-filled thermally protected motor

Capacitor rating:

60 microfarad

Operating Temperature:

104ÅãF (110ÅãF Max.)

Power cord length:

49 inches

Noise level:

≤ 63 dBA (Lp) (measured at 3 ft.)

Discharge pipe diameter:

3⁄4” or 1”

Discharge rate at 25 ft:

19 GPM

Discharge rate at 3 ft:

38 GPM

Shut-off head:

38 ft.

Normal running time:

10-12 seconds

Capacity:

3.2 gallons / 12.1 liters

Inlets:

2” (side), 1–1⁄2” vent (top)

Method of activation:

Membrane/microswitch

Shower/bathtub base height:

8” min

Weight:

28 lbs / 12.7 kg

Certifying agencies:

CSA (IPC, NSPC), IAPMO (UPC)

Recommended accessories:

Descaler, Sanialarm

Connections:

Rear outlet toilet, sink, shower/bathtub, washing

20 -5/16" machine (indirect connection via laundry sink)

Saniaccess 3 - 
SPECIAL ORDER

Sani 082

DESCRIPTION

The Saniaccess3 is a 1/2 HP pump system used to install a complete bathroom up to 15 feet below the sewer

line, or even up to 150 feet away from a soil stack. It incorporates a macerating system which can handle

human waste and toilet paper in residential applications. The blade is made out of a hardened stainless steel

material which eliminates the need for any service or replacement.

PRODUCT INFO

  • Discharges the waste through a 3 ⁄4” or 1” rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the system. This elbow can be rotated 360 degrees depending on the discharge installation.

  • Has been designed with a 1–1⁄2” vent connection on the top of the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.

  • Must be connected to Saniflo’s 1.28 GPF / 4.8 LPF rear discharge toilet. These toilets come in round and elongated (ADA compliant) models. More technical information on page 6.

  • Will also discharge gray water from any sink, bath/shower or urinal. The wastewater will drain into the system via two 2” inlets with built-in check valves on either side of the housing. Note that when adding a bathtub/shower, the base should be raised up by a minimum of 6” off the floor.

  • Designed with two easy access service panels located on top of the pump. On one side of the pump you can easily access the electrical components and the level

bottom of page