top of page

TECHNICAL SPECIFICATIONS

Pump type:

Macerator

Electrical:

120 V – 60 Hz / 4.5 Amps (Max)

Motor:

0.5 HP oil-filled thermally protected motor

Capacitor rating:

45 microfarad

Operating Temperature:

104ÅãF (110ÅãF Max.)

Power cord length:

51 inches

Noise level:

≤ 53 dBA (Lp) (measured at 3 ft.)

Discharge pipe diameter:

3⁄4” or 1”

Discharge rate at 15 ft:

17 GPM

Discharge rate at 3 ft:

27 GPM

Shut-off head:

30 ft.

Normal running time:

10-12 seconds

Capacity:

2.3 gallons / 8.7 liters

Inlets:

1–1/2” (side), 1–1⁄2” vent (side)

Method of activation:

Membrane/microswitch

Weight:

15 lbs / 6.8 kg

Certifying agencies:

CSA (IPC, NSPC), IAPMO (UPC)

Recommended accessories:

Descaler

Connections:

Rear outlet toilet, sink

Saniaccess2 - 
SPECIAL ORDER

Sani 081

DESCRIPTION

The Saniaccess2 is a 1/2 HP pump system used to install a half-bathroom up to 15 feet below the sewer

line, or even up to 150 feet away from a soil stack. It incorporates a macerating system which can

handle human waste and toilet paper in residential applications. The blade is made out of a hardened

stainless steel material which eliminates the need for any service or replacement.

PRODUCT INFO

  • Discharges the waste through a 3 ⁄ 4” or 1” rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the system. This elbow can be rotated 360 degrees depending on the discharge installation.

  • Has been designed with a 1–1⁄ 2” vent connection on the side of the pump housing. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.

  • Must be connected to Saniflo’s 1.28 GPF / 4.8 LPF rear discharge toilet. These toilets come in round and elongated (ADA compliant) models. More technical information on page 6.

  • Will also discharge gray water from a sink. The wastewater will drain into the system via a 1–1⁄ 2” inlet which is located on the side of the pump housing. Note that either side connection can be used for the vent or as an inlet.

  • Designed with two easy access service panels located on top of the pump. On one side of the pump you can easily access the electrical components and the level sensor. The other side allows access to the macerating blade for easy removal of foreign objects.

bottom of page