top of page
Sanishower - 
AVAILABLE IN STORE

Sani 010

DESCRIPTION

The Sanishower drain pump is used to pump gray water away from a variety of fixtures in residential

applications. The system is able to discharge the waste up to 12 feet vertical and/or 100 feet horizontal.

PRODUCT INFO

  • Discharges the waste through a 3/4” or 1” rigid pipe. A non-return valve is included on the discharge fitting assembly provided with the system. Unlike the other models, the discharge for this model is on the side of the enclosure.

  • Has been designed to be vented through a 1–1/4” or 1–1/2” pipe. The vent output is located on the top of the pump. The case has a knockout which along with the rubber adapter provided is used to connect to the vent pipe. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.

  • Discharges gray water from a shower or sink. The gray water will drain into the system via two 2” inlets (with built-in check valves) on either side of the housing.

TECHNICAL SPECIFICATIONS

Pump type:

Drain Pump

Electrical:

120 V – 60 Hz / 5.5 Amps (Max)

Motor:

0.2 HP oil-filled thermally protected motor

Capacitor rating:

25 microfarad

Operating Temperature:

104ÅãF (110ÅãF Max.)

Power cord length:

48–1/2”

Noise level:

≤ 44 dBA (Lp) (measured at 3 ft.)

Discharge pipe diameter:

3⁄4” or 1”

Discharge rate at 12 ft:

14 GPM

Discharge rate at 3 ft:

20 GPM

Shut-off head:

26 ft.

Normal running time:

3-5 seconds (Short bursts)

Capacity:

0.9 gallons / 3.4 liters

Inlets:

2” (sides))

Method of activation:

Membrane/microswitch

Shower/bathtub base height:

5” min

Weight:

12 lbs / 5.4 kg

Certifying agencies:

CSA (IPC, NSPC)

Recommended accessories:

Descaler

Connections:

Sink, shower

bottom of page